Heavily soiled floor tiles and flagstones can negatively affect the appearance of your entire home. Stubborn grease, ingrained dirt and old protective layers accumulate over the years and are barely removable with ordinary cleaning agents. HG Tile Cleaner Extra Strong offers the powerful support needed to effectively tackle these stubborn problems. This extremely strong cleaner restores the original cleanliness of your floor, so you can enjoy a clean and fresh living environment again.

Key benefits

• Extremely powerful action: Effortlessly removes stubborn grease, deep-seated dirt and old polish or protective layers.
• High efficiency: One 1-litre bottle is sufficient for treating 35 to 70 m² of floor surface.
• Versatile application: Suitable for floor tiles, flagstones and all types of natural stone, both for manual use and for scrubbing machines.
• Thorough deep cleaning: Penetrates deep into the pores of the tiles to soak off even the most stubborn dirt.

How it works

HG Tile Cleaner Extra Strong is formulated with active ingredients such as sodium hydroxide and disodium metasilicate. These substances quickly break down the molecular bonds of stubborn grease, dirt and old wax or polish layers. By scrubbing the liquid in and letting it work for a short time, the dirt is completely loosened from the surface, after which it can be easily removed with a floor cloth and clean water.

Composition

Ingredients

Contains: sodium hydroxide CAS: 1310-73-2, isotridecanol, ethoxylated CAS: 69011-36-5, disodium metasilicate CAS: 10213-79-3.

Usage & Dosage

Follow the steps below for the correct use of HG tile cleaner extra strong (product 20).

1. Dissolve half a litre of HG tile cleaner extra strong in half a bucket (5L) of lukewarm water.
2. Apply this generously to the surface to be cleaned using a floor cloth or mop. Do not treat more than 10 to 15m2 at a time.
3. Scrub the surface well with a scrubbing brush or broom.
4. Leave it to work for a few minutes and then scrub well again.
5. After this, remove the solution from the surface using a floor cloth.
6. Mop the floor thoroughly afterwards with clean water.
7. The result is a clean tiled floor.

For extremely strong and stubborn dirt or very old polish and other protective films: Dissolve 1 litre in a bucket with 4 litres of lukewarm water and follow the steps described above.

When using a scrubbing machine: Dissolve half a litre in 5 litres of water, depending on the degree of soiling.

Safety & Disclaimer

H314- Causes severe skin burns and eye damage.
P101- If medical advice is needed, have product container or label at hand.
P102- Keep out of reach of children.
P280- Wear protective gloves/protective clothing/eye protection/face protection.
P301+P330+P331- IF SWALLOWED: rinse mouth. Do NOT induce vomiting.
P303+P361+P353- IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water [or shower].
P305+P351+P338- IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P501- Dispose of contents/container to a collection point for hazardous or special waste.
Contains: sodium hydroxide CAS: 1310-73-2, isotridecanol, ethoxylated CAS: 69011-36-5, disodium metasilicate CAS: 10213-79-3.